Dazzle Algae Resist 50

Why:

• To prevent algae. A small application of an effective algicide weekly makes it difficult for algae to reproduce in swimming pool water.
• Algae Resist 50 is concentrated so you use very little.
  • A synergistic blend of 2 active compounds for significant improvement in the spectrum of algal, cyanobacteria and other microorganism species controlled 
• It works better when chlorine and other sanitizers are compromised, continuing to prevent algae when the risk of an infestation is at its highest;
  • Algae Resist 50 is not pH dependent. It continues to work when chlorine can be compromised from pH imbalance
  • Algae Resist 50 doubles its effectiveness with every 4°C rise in water temperature. Chlorine dissipates more quickly as water warms. 
  • Algae Resist 50 concentrates on surfaces, penetrating into pores and crevices, where algae hides. Chlorine can only go where the water takes it.
  • Algae Resist 50 is a powerful wetting agent, attacking the slimy membrane of algal species. Chlorine is unable to penetrate this membrane at normal levels.
  • The bottom line – Algae Resist 50 works better when chlorine and other sanitizers could be compromised. An insurance policy against unwanted algae.

When:

• Apply initially at the start of each pool season
• Then weekly thereafter
• An extra dose can be applied following inclement weather – heavy rain, thunderstorms
• Can be used at pool closing for protection against algae over the winter months

How Much:

• Initially – use 20 mls per 10,000 litres
• Weekly maintenance – use 10 mls per 10,000 litres
• Do not overdose. Algae Resist 50 is a low-foaming product. It can foam if overdosed or the pool water is aerated from a water feature or suction leak. Test a small amount if unsure.

How: 

• For best results, always apply Algae Resist 50 approx. 1 hour after a shock treatment, as part of a systematic approach to pool care
• Add by pouring the required amount around the edges of the pool
• Brushing the pool surfaces should have been done immediately after the shock treatment. If this wasn’t done or the product is being added without a shock treatment being employed, brush following application to liberate stubborn algae from the surface.